LFD's low buck truck build!

[Rokcrln]

Starting with the bottom place your tack weld about 1/2" from each side of each panel clip. Then when you get up to the top body line you will need to place a very small screwdriver in the gap and flex the metal in the direction you want it to go. Do this in little amounts at a time so you do not streach the metal. You want to change the curve ever so slightly! Once you have done this and the body stays were you want it and is flat then tack it in place about every 2" apart. Repeat for the other side. Do the same thing for the floor but panel clips are not needed unless you plan on painting and polishing your bed floor. I will be doing some form of a spray in or roll on bed liner so I did not spend as much time on the floor as I did the outer body. For the front I had to deal with the old gas doors. This added more tape and cut time but it is still the same process as the back.

Kevin
LFD Inc.