LFD's Shop Toys - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Rokcrln · 03-30-2008, 07:51 AM

We got a few hrs in today but not much do to dropping off customer projects and picking up new ones.

I decided to make a mock up door jamb to see if the hinge placment was going to work. I used my shrinker and streacher to make the jamb piece then Jim took over and made the mount and spot welded it all together while I went for coffee. When I got back (short walk) I found it all worked great. This is good because I have all the templete's made for how this one is set up and I will be using them again for anoter build comming up. While Jim was working on some 3/16 plates for the door it self for the hinges to mount thru I worked on the caps to cover the old strike area. They turned out real nice for a hammer job.

Kevin
LFD Inc.

03-30-2008, 07:51 AM	#10
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Re: LFD's Shop Toys We got a few hrs in today but not much do to dropping off customer projects and picking up new ones. I decided to make a mock up door jamb to see if the hinge placment was going to work. I used my shrinker and streacher to make the jamb piece then Jim took over and made the mount and spot welded it all together while I went for coffee. When I got back (short walk) I found it all worked great. This is good because I have all the templete's made for how this one is set up and I will be using them again for anoter build comming up. While Jim was working on some 3/16 plates for the door it self for the hinges to mount thru I worked on the caps to cover the old strike area. They turned out real nice for a hammer job. Kevin LFD Inc. Last edited by Rokcrln; 03-30-2008 at 07:54 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.