LFD's 4dr Tahoe Build - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Rokcrln · 10-11-2008, 09:41 PM

I got allot done today and would have finished the 4th door but I ran out of gas for my TIG. I started off by adding the second skin to the front of the door edge. This is to add strength to the front edge just like the factory did. Since mine did not have the factory door edge I had to make it this way. I first welded the edge all the way up the door making sure not to warp anything. Then I added an 1/8" Tig rod to the edge of that to give a thicker profile so their is more for the paint to stick to and to give a bit more metal to to scribe for my door gap. Then I sprayed some blue die on the edge of the door so when I scribed my 3/16" gap it would be allot easier to see and grind. After that was done I started welding up the inner door panel up until I ran out of welding gas.

Kevin
LFD Inc.

10-11-2008, 09:41 PM	#11
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Re: LFD's 4dr Burb Build I got allot done today and would have finished the 4th door but I ran out of gas for my TIG. I started off by adding the second skin to the front of the door edge. This is to add strength to the front edge just like the factory did. Since mine did not have the factory door edge I had to make it this way. I first welded the edge all the way up the door making sure not to warp anything. Then I added an 1/8" Tig rod to the edge of that to give a thicker profile so their is more for the paint to stick to and to give a bit more metal to to scribe for my door gap. Then I sprayed some blue die on the edge of the door so when I scribed my 3/16" gap it would be allot easier to see and grind. After that was done I started welding up the inner door panel up until I ran out of welding gas. Kevin LFD Inc.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.