292 to 350 engine swap, I don't need a different crossmember do I? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Patsfan34 · 12-16-2009, 08:27 PM

I started breaking down my chassis today, it's a 68 GMC 4x4 SWB that I'm turning into a 70 Chevy 4x4 SWB. The current engine is getting yanked out but while I was pulling drive shafts and shocks and other stuff, I noticed the motor mounts on the 292 have stands and all kinds of stuff. Once I yank this engine, I can just buy 350 motor mounts and be done right or no? Also, with the 292 to 350 swap will the placement of the tranny and t/case stay in the same place?

Happy Holidays,

Patsy!

12-16-2009, 08:27 PM	#1
Patsfan34 Registered User Join Date: Dec 2008 Location: New England Posts: 661	292 to 350 engine swap, I don't need a different crossmember do I? I started breaking down my chassis today, it's a 68 GMC 4x4 SWB that I'm turning into a 70 Chevy 4x4 SWB. The current engine is getting yanked out but while I was pulling drive shafts and shocks and other stuff, I noticed the motor mounts on the 292 have stands and all kinds of stuff. Once I yank this engine, I can just buy 350 motor mounts and be done right or no? Also, with the 292 to 350 swap will the placement of the tranny and t/case stay in the same place? Happy Holidays, Patsy! Last edited by Patsfan34; 12-16-2009 at 08:28 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.