Project: "Full Metal Yellow Jacket" Build Thread - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Kim57 · 01-30-2010, 07:32 PM

1Bad62
I looked at your build thread and think you would be able to make your bed tilt.
If you make a frame that attaches to the bottom of your bed and lays over the original truck frame it would work. You may have to raise your bed floor up for clearance but I think you could make it work.
I'm raising my bed floor up because my truck won't haul anything but a$$.
You want the pivot to be as low as possible to keep the front of the bed from getting into the back of the cab.
Kim

01-30-2010, 07:32 PM	#10
Kim57 Registered User Join Date: Aug 2007 Location: Corona, California Posts: 7,998	Re: Project: "Full Metal Yellow Jacket" Build Thread 1Bad62 I looked at your build thread and think you would be able to make your bed tilt. If you make a frame that attaches to the bottom of your bed and lays over the original truck frame it would work. You may have to raise your bed floor up for clearance but I think you could make it work. I'm raising my bed floor up because my truck won't haul anything but a$$. You want the pivot to be as low as possible to keep the front of the bed from getting into the back of the cab. Kim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.