New vendor for you wiring needs!

[Pyro]

Well, sort of new. I've been around awhile but have been so busy setting the new shop up that I didn't get much time to be on here. Now that I have working internet at the shop it's a lot easier

Downriver Motorsports Wiring is a michigan based company. We handle everyhting from basic repair to full vehicle wiring. If you need a custom wiring harness built from scratch to fit a LS engine in you truck we do that. If you have a factory harness that you want modified to work in your truck we do that too.

I started the company after building prototype harnesses for 10 years for a supplier for the Big 3. While I was doing that I started wiring drag cars, hot rods, and such on the side. We only use top quality parts and never skimp on quality. If you have us modify a stock harness for you it won't come back without new coverings on it, profesionally taped using correct tape, not just cheap vinyl tape, and any unused circuits will not just be taped inside the harness, we remove the circuits properly. If we have to remove a wire from a splice we redo the splice so that one wire isn't hanging out. When the harness is done it will be bundled with the smallest diameter covering that will fit.

I know not everyone can bring thier truck to us to have it wired, but if you can give dimensions of what you need built for harnesses we can build it.

I also have a 1986 GMC Sierra standard cab long bed that's getting a 6.0 and a 4L80E setup and a 1991 Chevy Suburban that's rusty as heck, but still hauls like the day it came out of Flint, keep your eyes on the forums for updates on these two.