![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#11 |
Registered User
Join Date: Dec 2012
Location: Rochester, KENT
Posts: 10,508
|
Re: Grizz's Redneck Express 1966 Chevy Short Fleetside RESTO-GO!
So.........
Cat Stevens sang “The first cut is the deepest” Not sure if its that relevant to this truck, but once marked out, I fitted a new cutting disc and set to work cautiously ![]() Cut through. Then used a file to tidy up the corners and a flap disc to clean the etch primer away. ![]() More fettling and fine tuning needed. ![]() Everything takes time. But got it done. ![]() Then earthed up the front panel after practicing and lowering the power feed but increasing wire speed on some of the scrap metal. Started tacking one spot at a time to prevent warping. ![]() Ground back. Holes filled, dents mostly gone, needs a skim of filler eventually ![]() Etch primer both sides. ![]() And all of this just to remove this bit of mess. ![]() So that was day one. Two hours in total, start to finish.
__________________
MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE. |
![]() |
![]() |
Bookmarks |
|
|