Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
03-31-2021, 08:01 PM | #1 |
Registered User
Join Date: May 2013
Location: You're the only 10 I see
Posts: 367
|
Roof patch causing warp / oil canning
I am fixing an old CB antenna hole in my roof. The hole was in the center of the cab and I cut a 2" x 2" square to patch in with new metal.
About half way through tacking, I realized I had some major oil canning going on, and a hump on the sides and a valley on the top and bottom. The hump was about 1/8" up and the "valleys" also about 1/8" deep. I tacked fairly slow, 4 or 5 at a time and I don't think heat was the issue. These issues extended almost a foot around my patch in all directions. I decided to cut out what I had put in and everything settled back to where it needed to be and there is no warp. What did I do wrong with this patch, and how to I weld in this piece without the warp and oil canning?
__________________
1972 C20 |
Bookmarks |
|
|