The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Suspension

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-13-2023, 11:51 AM   #1
14U2NV
Registered User
 
Join Date: Mar 2002
Location: Midlothian, Tx
Posts: 156
QA1 Rear Trailing Arm - Need a measurement

Hey all, I'm a longtime member that is finally getting around to rebuilding 3 Blazers I have had for 20+ years. Haven't been on for years! I am looking to use the QA1 trailing arm rear suspension to convert over to 2wd. I know the 4x frames are different from the 2x frames that kick out to catch the coils.

Looking at the frame dimensions that have been posted on this site for both the 2x and 4x Blazer frames, I believe the part of the frame where the coils/panhard bar actually mounts on the QA1 kit are the same width, 2x vs 4x. Would anyone with the QA1 rear kit installed be able to measure the frame width (outside to outside) where the coil mounts go? If it's the same, I will just lop off their c notch right before it kicks out and weld in my own notch. Also, it doesn't have to be on a blazer, any truck 63-72 should be the same.

I'll post up my Blazers soon and officially re-introduce myself on another post!

Thanks,
Chad
14U2NV is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:43 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com