Impala SS Rear Disc Brake Brackets

[Captainfab]

Sorry but no I don't have any pics other than what I've posted. I have hinted to a few customers about posting pics, but so far no one has that I'm aware of.

Originally Posted by staggerd86c-10

any pics of the guys trucks that have bought these brackets?

Pat, I'll send you a PM. Thanks

Originally Posted by 80stepsideguy

Captfab,
ill take a set as well i am looking to turn my rear setup from drum to disc and this will look alot better in the backsides of the 20s i got on my truck

thanks
pat

[creep]

Shot in the dark here, but do you know if they will fit an 8.2 10 bolt from a Chevelle? If not could you give me some dimensions like the offset of the SS rotors, how thick they are at the wheel mounting surface and the distance from the backing plate flange to the axle flange on the 12 bolt rear end?

[Captainfab]

No these brackets won't work on a 8.2 passenger car 10 bolt. The axle tube flange has a different bolt pattern and the Impala SS rotors won't fit since they are a 5 x 5 bolt pattern and the 10 bolt you have is 5 x 4.750 Of course you could drill some holes and they might work, but I don't know if the calipers and rotors would line up on the 8.2 10 bolt.

I'll have to look up those dimensions and get back to you.

Originally Posted by creep

Shot in the dark here, but do you know if they will fit an 8.2 10 bolt from a Chevelle? If not could you give me some dimensions like the offset of the SS rotors, how thick they are at the wheel mounting surface and the distance from the backing plate flange to the axle flange on the 12 bolt rear end?

[creep]

Thanks. I'm going to have my axles redrlled to 5x5 to match the front, just hoping I wouldn't have to do rotors too.

[Captainfab]

Originally Posted by creep

Shot in the dark here, but do you know if they will fit an 8.2 10 bolt from a Chevelle? If not could you give me some dimensions like the offset of the SS rotors,

From the inside of the hat to the inside surface is about 2.090"

Originally Posted by creep

how thick they are at the wheel mounting surface

The one I have here measures .242"

Originally Posted by creep

and the distance from the backing plate flange to the axle flange on the 12 bolt rear end?

That varies from 2.437" to 2.500" depending on how the gears are setup. The bolt pattern on the axle tube flange is 2.625" vertically and 3.375 horizontally.

[68 TT]

Originally Posted by Captainfab

The bolt pattern on the axle tube flange is 2.625" vertically and 3.375 horizontally.

The car housing end bolt pattern is 3-1/8" apart on the top, 2-11/16" apart on the bottom and the sets are 2-7/16" apart top to bottom.

If the hole in the middle of the bracket is small enough you could just redrill the plate for a dual bolt pattern so it fits cars and trucks.