Rat repair. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

swamp rat · 09-21-2013, 01:33 AM

I have a question, can you pull the inner fender wells out underneath the fenders? or do you have to take the fender off to get at them? it will be a while till i get to that but i need to do a little rust repair where that bracket is welded on by the frame rail. I figure i an try that first before i try a door or rocker.

Crash_OK · 09-21-2013, 07:30 AM

Quote:

Originally Posted by swamp rat

I have a question, can you pull the inner fender wells out underneath the fenders? or do you have to take the fender off to get at them? it will be a while till i get to that but i need to do a little rust repair where that bracket is welded on by the frame rail. I figure i an try that first before i try a door or rocker.

You can remove the inner fender with removing the fender without any problem.. Great Job so far..

09-21-2013, 01:33 AM	#1
swamp rat Registered User Join Date: Oct 2007 Location: Spanaway Posts: 8,451	Re: Rat repair. I have a question, can you pull the inner fender wells out underneath the fenders? or do you have to take the fender off to get at them? it will be a while till i get to that but i need to do a little rust repair where that bracket is welded on by the frame rail. I figure i an try that first before i try a door or rocker. __________________ Mike. Swamp Rat build thread : http://67-72chevytrucks.com/vboard/s...d.php?t=595019 72 3/4T 4X4 4" BDS Lift 33" BFG's

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.