Restoring Rusty - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Gregski** · 04-15-2021, 11:51 PM

so adding two shims to front and back of the upper control arm got me in the OK(ish) ballpark with the same negative camber on both sides, I may revisit both sides after some shake down driving and see if I can get them both slightly under -1°

4u2nv · 04-16-2021, 06:44 AM

Quote:

Originally Posted by Gregski

so adding two shims to front and back of the upper control arm got me in the OK(ish) ballpark with the same negative camber on both sides, I may revisit both sides after some shake down driving and see if I can get them both slightly under -1°

I like your method .

04-15-2021, 11:51 PM	#1
Gregski Post Whore Join Date: Aug 2014 Location: Sacramento, CA Posts: 10,811	Re: Restoring Rusty so adding two shims to front and back of the upper control arm got me in the OK(ish) ballpark with the same negative camber on both sides, I may revisit both sides after some shake down driving and see if I can get them both slightly under -1° Attached Images Last edited by Gregski; 04-16-2021 at 12:10 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.