10-16-2008, 02:18 PM | #6 | |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,921
|
Re: CPP Rant !!!
Quote:
I've had to do it before & it was never an issue. The nuts threads were fully engaged on the BJ shaft, the cotter-pin fits the notch in the castle nut, & the assembly was tightened enough that the tapered-shaft was firmly seated within the spindle (needed a pickle fork to separate the two pcs).
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. Last edited by SCOTI; 10-16-2008 at 02:19 PM. |
|
Bookmarks |
|
|