|
10-03-2015, 06:35 PM
|
#1 |
|
Registered User
Join Date: Sep 2015
Location: carrollton texas
Posts: 4
|
Check this out
I came up on this perfect bed floor for my 69 swb.
|
|
|
|
10-03-2015, 06:43 PM
|
#2 |
|
Registered User
Join Date: Oct 2008
Location: Marianna Arkansas
Posts: 7,257
|
Re: Check this out
Great find there getting pretty hard to come by. I have four that are as close to perfect hidden out, two shorts and two longs. you would think the long would be harder to find than the shorts cause they are worked more maybe?. Jim
|
|
|
|
|
10-03-2015, 07:06 PM
|
#3 |
|
Registered User
Join Date: Sep 2015
Location: carrollton texas
Posts: 4
|
Re: Check this out
I'm stoked. I picked it up for two hundred bucks. Its near perfect zero rust.
|
|
|
|
|
10-03-2015, 08:05 PM
|
#4 |
|
Senior Member
 
Join Date: Jan 2007
Location: Turlock, CA
Posts: 8,464
|
Re: Check this out
good find, great price!
__________________
I live in California, but identify as a Texan  "If a job's worth doing, it's worth doing well" Survivor "Lil’ Mint" (67 c10 40k mile light green original paint) Project "C10 Fever" (68 factory black 396 swb) Project "Little Sister" (70 c10 blue original paint refresh) Project "Blue Bomb" (70 c30 blue original paint refresh) SOLD Project "Vitamin C" (71 c10 orange original paint refresh) SOLD |
|
|
|
10-04-2015, 10:02 AM
|
#5 |
|
Registered User
Join Date: May 2014
Location: Pittsburgh, PA
Posts: 712
|
Re: Check this out
Looks clean! How difficult are they to remove/install? Just bolts or are there welds involved too?
__________________
Bill 2004 Chevy Silverado Z71 Ext Cab 1500 1972 Chevy K-10 SOLD 1967 Chevelle SS |
|
|
|
|
10-04-2015, 10:09 AM
|
#6 |
|
Registered User
Join Date: Oct 2008
Location: Marianna Arkansas
Posts: 7,257
|
Re: Check this out
Not hard to do it is helpful to have an impact wrench to TIGHTEN [not loosen] the bolts or they will just round out their notches. There are two small spot welds on the back side of the bedside holding the bedside onto the floor. Jim
|
|
|
|
|
10-04-2015, 03:16 PM
|
#7 |
|
Registered User
Join Date: May 2014
Location: Pittsburgh, PA
Posts: 712
|
Re: Check this out
Thanks Jim, I'm going to give it another shot. My only problem is the 4 phillips heads. They rounded off. Maybe I can weld a nut to them and remove them that way
__________________
Bill 2004 Chevy Silverado Z71 Ext Cab 1500 1972 Chevy K-10 SOLD 1967 Chevelle SS |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
