Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-16-2017, 11:30 AM | #20 |
Registered User
Join Date: Jan 2012
Location: Killeen, Tx
Posts: 1,352
|
Re: 1962 chevy c10 update.
Just a little update. After some hard work trying to figure out how to get the T5 in it finally happened. It's in! Last Saturday I want on a test drive to test it out. The trans works great! Shifts good, performs better than I expected! I must have sucked up some trash in my carbs because I had a major stall and had to limp it to the body shop. After a week of setting AC (fabricator at the Body shop) help me clear out the trash and get it going. Now after a big tune up, carb adjustment and linkage reset I'm running better than before. i still have to install the high hump, new carpet and shifter boot and the trans install will be done!
I had to remove the torsion bar x member to get the trans in. Not a good 360 pic but you can see that there is plenty of room now. Except I have to cut in between the top front tunnel cover bolts. This will allow the top of the trans to clear. If you have a high hump this cutting isn't required. Trans installed! As you can see the lower part of the T5 is what was hitting the torsion bar x member. It wouldn't allow it to slide all the way back into the x frame. Transcend shifter installed! Here is a shot when I went to pick up my truck.
__________________
John Z 1962 Chevy C10 Stepside 62 Barnfind My build tread: http://67-72chevytrucks.com/vboard/s...d.php?t=507513 Last edited by 62 Barnfind; 01-16-2017 at 11:42 AM. |
Bookmarks |
|
|