1950? S-10 tdi

[61_FL_Apache]

Like the Jeep CJ6.

[lower50's]

Originally Posted by 6DoF

i was so weirded out by the pipe going all the way across the engine bay ... then remembered it wasn't a crossflow head. at least you got room!

Ya lol I will be making the pipe a bit more shinny.

Originally Posted by 61_FL_Apache

Like the Jeep CJ6.

It's cool eh

[lower50's]

Took the front clip apart to finish up a few things before the front end goes to get blasted. Now you can see the bumper support and front cross member.

[lower50's]

So Saturday I took the fenders and rad support to to the sand blaster, should have them back in a week. I got all the brake lines run, cleaned up the motor, then I started putting power to the truck. I got the trans fan, heater, ignition, motor computer, glow plugs, head light circuit, starter, and gauges all hooked up and working. I just work a fuse at a time. Once all the wires are run it is going to end up nice and neat.

[6DoF]

Originally Posted by lower50's

Once all the wires are run it is going to end up nice and neat.

unless you have 1 bad ground somewhere .... then it's going to end a rats nest of sorrow.

[Tempest67]

that sits in there nice,

I think it is cool to have something different, no one will ever guess what that motor is from

nice job and thanks for sharing (hope your helpers are doing well - dogs)

[lower50's]

Originally Posted by 6DoF

unless you have 1 bad ground somewhere .... then it's going to end a rats nest of sorrow.

Ya, I make sure my - are as good as my +

Originally Posted by Tempest67

that sits in there nice,

I think it is cool to have something different, no one will ever guess what that motor is from

nice job and thanks for sharing (hope your helpers are doing well - dogs)

Thanks, I have always liked the strange motor swaps.
Yes they are good and help whenever they can.