Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
03-14-2022, 11:08 AM | #1 |
Registered User
Join Date: Sep 2016
Location: Tulsa, OK
Posts: 410
|
Re: Doing LS Swap - I have no idea what I'm doing!
Well, haven't had much to post about lately - or, at all for that matter. I haven't had time to get to the truck with family time. I did spend about an hour in the garage the other night (Friday night) after everyone was asleep.
I put the exhaust manifolds on, the new dipstick tube (Super hard, I know), and started laying out the wire harness. I hooked up all the connections I could easily get to on top of the motor (injectors, alternator, coolant sensor). I still need to verify some of the locations for the other stuff and try and get to the rear and under the motor to hook up the rest of the connections. Anybody know of a diagram that shows where all the connections are located?
__________________
1971 C10 - Hugger Orange/White My Build Thread: http://67-72chevytrucks.com/vboard/s...d.php?t=780197 LS Swap Thread: https://67-72chevytrucks.com/vboard/...d.php?t=811460 |
03-15-2022, 09:15 AM | #2 | |
Senior Member
Join Date: Jul 2015
Location: Warrenton VA
Posts: 1,009
|
Re: Doing LS Swap - I have no idea what I'm doing!
Quote:
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop. 07 Silverado Classic 2wd 95 Camaro 427SBC/TH350 |
|
03-15-2022, 11:20 AM | #3 | ||
Registered User
Join Date: Sep 2016
Location: Tulsa, OK
Posts: 410
|
Re: Doing LS Swap - I have no idea what I'm doing!
I'm going with the Jeep Wrangler tank. If I remember right, I ordered one for a '90 model FI tank. I'm mounting it under the bed, behind the axle.
Quote:
Quote:
Anyway, I was looking for a picture of the engine that showed where each connection point was located. I think I have most of them figured out, but I second guess myself too much and worry about hooking things up correctly. I have the injectors, alternator, coolant connection hooked up. Pretty sure I can do the transmission connections. But, there are several like the oil pressure (I think it's behind the engine), knock sensors, MAF (I'm afraid I may have a wrong connection type for it), and some others that I don't remember what they are called. Luckily, all of my connections on the wiring harness are labeled. I just need to figure out where those connections are on the truck motor. I've seen a lot videos on the car motors, but the truck intake throws me off when when looking at pictures/videos 'cause they are slightly different.
__________________
1971 C10 - Hugger Orange/White My Build Thread: http://67-72chevytrucks.com/vboard/s...d.php?t=780197 LS Swap Thread: https://67-72chevytrucks.com/vboard/...d.php?t=811460 |
||
Bookmarks |
|
|