Front suspension work

[MASTERBrian]

Finally got the entire passenger side done. Anti sway bar link, both sides, lower ball joint, inner and outer tie rods and wheel hub on passenger side. Ordering hub for driver side tomorrow, then I'll do the inner/ outer tie rod and lower ball joint on driver side.

Still debating on upper control arms in order to tackle those ball joints.? Doesn't seem hard, I just need to see how they re-shim them to get them close. At that point I'll need tires and alignment.

I still have the stabilitrak and traction control lights coming on 50% of time after replacing outer tie rod a while back.

Is this work likely setting them off?