06-27-2021, 01:56 PM | #1 |
Senior Member
Join Date: Mar 2005
Location: Jurupa Valley, Ca
Posts: 1,209
|
Torque Converter
Does a higher speed TQ, say 2400 or so load the engine at an idle less than a stock converter?
__________________
Terry 1970 Custom Camper/C20 , GM Crate 350/7004R, Dana 60, factory AC |
06-27-2021, 01:59 PM | #2 |
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
Re: Torque Converter
In a word.....YES! If you have a hotter camshaft, the looser converter will let you idle at the light, without stalling. LONGHORN
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
06-29-2021, 01:20 PM | #3 |
Registered User
Join Date: Dec 2012
Location: Temple City
Posts: 3,560
|
Re: Torque Converter
Yes by a considerable amount. Alot of stock converters are in the 1200-1500rpm range.
Even a 2000 stops alot of the creep from the convertor trying to fluid lock. This for a 3 speed auto. Personally I like to have my converter stall to be lower then highway rpm. I did a 3500rpm stall when highway rpm was 2800 at 70mph. Sure it was very snappy, and had passing power at any point. I just couldn't haul anything with the truck besides ass. For a 4 speed lock up like a 4L65E. The above doesn't really apply except in terms of towing or hauling alot of weight. |
Bookmarks |
|
|