Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
12-03-2021, 12:09 AM | #1 |
Senior Member
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,426
|
Possible Quadrajet issue
Disclaimer, I haven't rebuilt a carb yet, but at some point I will
Anyways, of course, my Quadrajet carb book is back at home, so the answer might be in that, but I figured I would ask while I'm still here in Milly. On the vacuum port circled in red, I pulled the cap off and fuel spilled out It doesn't seem that fuel is coming out when the cap is on though. Also, when I put the cap back on, I noticed the port was a little bit loose and air bubbles formed around where the port goes into the carb body. Picture is from when I first put the carb on the engine over 3 years ago. Anyone seen that before? Have any advice? Thanks!
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
Bookmarks |
|
|