My '67 Fleetside C10 renew - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Low Elco · 10-19-2012, 11:16 PM

Yaaaay! Hot tip- take your sander and round one side of those d-blox over on about a 1/8 radius. They tend to dig in as you approach level changes. Also, most paint store cats are hot rodders-let em know what you're up to, they'll usually be helpful. You got a roll of 80 and a roll of 150 stickyback and some guide coat, right? I really like that 3m stuff. Remember, sand at a 45 angle away from you, long a stroke as possible, alternating directions to make an x. Hope im not being a pushy ass, just hoping your truck comes out good, youve made a great start! Good Luck!
Posted via Mobile Device

10-19-2012, 11:16 PM	#11
Low Elco Registered User Join Date: Apr 2003 Location: Indep, MO Posts: 5,893	Re: My '67 Fleetside C10 renew Yaaaay! Hot tip- take your sander and round one side of those d-blox over on about a 1/8 radius. They tend to dig in as you approach level changes. Also, most paint store cats are hot rodders-let em know what you're up to, they'll usually be helpful. You got a roll of 80 and a roll of 150 stickyback and some guide coat, right? I really like that 3m stuff. Remember, sand at a 45 angle away from you, long a stroke as possible, alternating directions to make an x. Hope im not being a pushy ass, just hoping your truck comes out good, youve made a great start! Good Luck! Posted via Mobile Device __________________ Boppa's Old Yeller Truck Build, Old Yeller's New Heart! Project Buzz Bomb Flyin' Low! Last edited by Low Elco; 10-19-2012 at 11:25 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.