Hazard Switch wiring

[roll_the_dice]

I am OK with wiring, but it always scares me for some reason. I get through it fine, but I always overthink things...anyway, I have a signal stat 105 hazard switch with original harness for a 64-66 truck (I think)...that is how it was sold to me. I also just purchased a new turn signal switch from AAW. I have an AAW wiring setup also. I was going to plug the 2 plugs from the turn signal switch to the hazard switch and then repin the end of the hazard switch to the AAW harness..sounded easy enough...until I looked at the wiring. I can't figure out which turn signal connection goes on top or bottom of the hazard switch. I thought the colored wires should line up, but they don't (blue to blue, green to green, etc). Should they or are some wires crossed to make the hazards work? Here are a few pictures that show the wiring of the harnesses. All the wires are present they just don't line up. If they are supposed to I can make that happen, but want to make sure before I do it. I searched google and here and found some info, but nothing with any diagram I could decipher. Any help would be appreciated. Thanks