Need recommendations for filler and single stage paint

[ItWillBeSlow]

Originally Posted by May70

How did you end up stripping all the paint from the inside btw?

I used a stripper disc on an angle grinder for the open flat areas, wire wheels for the curved areas, and 2”Roloc stripper pads on a die grinder where needed. Then I went over it a couple times by hand with 80 grit paper. The roof panel is rough working overhead, but it’s not terrible.

[May70]

Originally Posted by ItWillBeSlow

I used a stripper disc on an angle grinder for the open flat areas, wire wheels for the curved areas, and 2”Roloc stripper pads on a die grinder where needed. Then I went over it a couple times by hand with 80 grit paper. The roof panel is rough working overhead, but it’s not terrible.

How long did all that take you? Man sounds like a while

[ItWillBeSlow]

Originally Posted by May70

How long did all that take you? Man sounds like a while

I would guess I had 20-30 labor hours in stripping and prepping the interior in general. Also a few gallons of sweat and at least 1 case of beer. Someone with more experience could probably have done it faster.

It was tedious for sure but I am happy with how the end result was for the epoxy.