The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 03-30-2011, 08:48 PM   #1
Groyd
Registered User
 
Groyd's Avatar
 
Join Date: Apr 2009
Location: Edmond, OK
Posts: 393
Fuel Pump/Sending Unit Question

I have a '51 on a '97 s-10 frame. I've got a 5.3 from a '04 GMC Sierra.

Question : I picked up a different fuel pump to get the right pressure, but the sending unit for '96 and up s-10's doesn't allow you to change the pump . You have to change out the entire sending unit. Would I be better off getting a 95 or older sending unit and changing the pump?

Question : I know a lot of people with these trucks do rear mounted tanks. What would be the best fit in the s10 frame? Has anyone got any pics of something different in the s10 frame? Is the blazer tank the best bet? I just don't want it hanging out under the truck looking like trash.

Thanks,

MG
__________________
1951 Chevy 3100/S-10:
http://67-72chevytrucks.com/vboard/s...d.php?t=406072
1957 Chevy 3200
1971 2WD Blazer - Sold
Groyd is offline   Reply With Quote
Old 03-31-2011, 08:59 AM   #2
usmcchevy
Has more rust than truck...
 
usmcchevy's Avatar
 
Join Date: Apr 2005
Location: Ivanhoe, MN
Posts: 2,421
Re: Fuel Pump/Sending Unit Question

If you can change the pump on the older sending unit, that sounds the easiest.

Most change to a rear tank here because most of our trucks here still had the in cab tank. I just needed a new tank and wanted room in the cab. If I had a factory tank like yours I would have left it where it was
__________________
1972 Custom/10 SWB, 4.8/4l80e
Build thread

LSx Swap FAQ index
usmcchevy is offline   Reply With Quote
Old 03-31-2011, 05:14 PM   #3
67C10BUB
Registered User
 
67C10BUB's Avatar
 
Join Date: Aug 2010
Location: Alta Loma, CA
Posts: 610
Re: Fuel Pump/Sending Unit Question

I built a 94 S10 with a Corvette LT1 350 in it (fuel injected). I believe that I just got the 94 Camaro fuel pump and swapped it into the fuel pump/sending unit setup in the stock tank. It worked out great. So, assuming that the 94 tank is the same as the 96, then I would just get the older style one with the replaceable pump.
__________________
67 5.3L Build
67C10BUB is offline   Reply With Quote
Old 03-31-2011, 06:20 PM   #4
Clyde65
1965 Chevy C10, 2005 4.8L/4l60
 
Clyde65's Avatar
 
Join Date: Aug 2004
Location: DFW Texas
Posts: 8,540
Re: Fuel Pump/Sending Unit Question

IDK about an LT1 but the LS 5.3 will need constant 58psi at the rail to run properly. alot of guys use the walbro 255, IDK if they have one that would fit on what your wanting to convert.
__________________
Clyde65

Rebuild of Clyde
http://67-72chevytrucks.com/vboard/s...84#post8338184

69 Aristocrat Lo Liner build
http://67-72chevytrucks.com/vboard/s...84#post7561684



support our troops!
Clyde65 is offline   Reply With Quote
Old 03-31-2011, 07:03 PM   #5
Groyd
Registered User
 
Groyd's Avatar
 
Join Date: Apr 2009
Location: Edmond, OK
Posts: 393
Re: Fuel Pump/Sending Unit Question

Quote:
Originally Posted by Clyde65 View Post
IDK about an LT1 but the LS 5.3 will need constant 58psi at the rail to run properly. alot of guys use the walbro 255, IDK if they have one that would fit on what your wanting to convert.
The fuel pump I picked up was AcDelco Part# EP-381 it has 65 psi? I was told it would fit right into the s10 sender, but I don't think they knew about s10's that were '96 or newer.

Thanks for all the answers. I'm glad this many people look at the LSx swap section everyday. I think I'll scour the junkyards looking for a fuel sender from a '95 or older s10 tomorrow.

-MG
__________________
1951 Chevy 3100/S-10:
http://67-72chevytrucks.com/vboard/s...d.php?t=406072
1957 Chevy 3200
1971 2WD Blazer - Sold
Groyd is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:21 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com