Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
04-28-2021, 02:51 PM | #1 |
Senior Member
Join Date: Nov 2013
Location: East Tennessee
Posts: 2,112
|
Re: Questions for the welding pros
How about tips for plug welding?
I bought this bed side panel and the stake pocket was mis-aligned enough that the rear cross sill would not go into place. I used an end mill to cut the spot welds and remove it so that I didn't break thru. I plan on plug welding back in the same holes after I get it re-aligned. cleaned off and sprayed with weld-thru primer
__________________
1967 C10 Step side 1968 C10 Step side 1970 Chevrolet K/5 Blazer 1972 Chevrolet K/5 Blazer ............. |
04-28-2021, 08:05 PM | #2 |
Registered User
Join Date: Jan 2013
Location: Leonardtown, MD
Posts: 1,636
|
Re: Questions for the welding pros
What size diameter was your end mill?
__________________
Robert |
04-28-2021, 08:46 PM | #3 |
Senior Member
Join Date: Nov 2013
Location: East Tennessee
Posts: 2,112
|
Re: Questions for the welding pros
__________________
1967 C10 Step side 1968 C10 Step side 1970 Chevrolet K/5 Blazer 1972 Chevrolet K/5 Blazer ............. |
Bookmarks |
|
|