CPP Drop Spindle Special

[yellowGT]

Reason I ask is because I have two sets of drop spindles but don't know what they fit. I was hoping maybe by determining the size of the bj I could figure that out. I know the bottom taper hole is 7/8" and then it tapers.
Posted via Mobile Device

[CPPJEFF]

Originally Posted by yellowGT

Reason I ask is because I have two sets of drop spindles but don't know what they fit. I was hoping maybe by determining the size of the bj I could figure that out. I know the bottom taper hole is 7/8" and then it tapers.
Posted via Mobile Device

We dont measure spindles like that here, we have fit parts that we measure these spindles with. If you want to determine what spindles you have i will give you all the parts numbers as followed to run down to your parts store and determine what you have. Keep in mind its not just the ball joints but the outter tie rod tapers are different also

1963-70 upper balljoint fa480 lower fa481 outer tierod es350-L
1971-72 upper balljoint fa683 lower fa1014 outer tierod es415-r
1973-88 uper balljoint fa903 lower fa1014 outer tierod es409r

Hope this helps, there is no easy way to measure these, fit parts will give you the answer. Thanks