D52 Caliper Rear Disc Brake Brackets

[Captainfab]

No. the width increases aproximately 1/2", depending on the particular rotors you buy. If you can find a good useable set of original rotors, they had the thinner stamped steel hat. I haven't found that style available from the aftermarket, but you may be able to. So those wouldn't increase your width any.

Originally Posted by Strut

Does the 12 bolt rearend width (in a 72) stay the same with this kit installed?

[lolife99]

Originally Posted by Captainfab

No. the width increases aproximately 1/2", depending on the particular rotors you buy. If you can find a good useable set of original rotors, they had the thinnes stamped theed hat. I haven't found that style available from the aftermarket, but you may be able to. So those wouldn't increase your width any.

Any reason to worry about the lug stud length being too short?
Also 1/2" total width,... or per side?

[Captainfab]

I haven't checked to see if it would be a concern or not.....I probably should do that. Yeah that 1/2" is total, ~1/4" per side.

Originally Posted by lolife99

Any reason to worry about the lug stud length being too short?
Also 1/2" total width,... or per side?