Static Drop Spring Question

[NC_John]

I want to do a down-and-dirty (read: CHEAP) drop just to make blu look a bit cooler. Long term plans are spindles or bags but with it needing so much other stuff right now and my budget already destroyed, I just need to get it lower.

Can I simply install the mcgaughy's 2" drop front and 4 or 5" drop rear springs? (I don't want to cut springs, as inexpensive as these ones seem to be) Will I be able to get any kind of alignment without dropped spindles or have any clearance issues in the back? I expect I'll need to get a shock relocator kit for the rear (it needs new shocks as well so I'll just get a set of AC Delcos for now). Its not a daily driver so I can live with losing some ride quality.

Seems to be the least expensive way for me to at least get out of the nosebleed seats for now.

Any issues?

Thanks!

[lolife99]

2" front and 5" rear is a good plan if you plan on using drop spindles later.
But the front will be higher now.
You will also need an adjustable rear track bar for the rear.
I suggest www.earlyclassic.com for parts.

[NC_John]

Originally Posted by lolife99

2" front and 5" rear is a good plan if you plan on using drop spindles later.
But the front will be higher now.
You will also need an adjustable rear track bar for the rear.
I suggest www.earlyclassic.com for parts.

Do you mean the front will be higher than the rear with the 2" front 4/5" rear until I get drop spindles? That might encourage me to expedite the spindles then.

I assume you mean the adjustable panhard bar?

Thanks!

[lolife99]

Originally Posted by NC_John

Do you mean the front will be higher than the rear with the 2" front 4/5" rear until I get drop spindles? That might encourage me to expedite the spindles then.

I assume you mean the adjustable panhard bar?

Thanks!

yes and yes.

[slow-1]

From my study's of the subject, I am going to do a 2/4 drop on mine...all of the pictures I've seen of 2/4 drops the truck sits level...with a 2/5, the rear is gonna be lower than the front.

[NC_John]

Originally Posted by lolife99

yes and yes.

nuts! well heck with that!

Originally Posted by slow-1

From my study's of the subject, I am going to do a 2/4 drop on mine...all of the pictures I've seen of 2/4 drops the truck sits level...with a 2/5, the rear is gonna be lower than the front.

I guess that is what I'll do for now too. Then add spindles in the front and blocks in the back later to get a bit lower....

Thanks guys.

[oldblue1968chevy]

Cut 1 coil in the front springs
Install a drop block (2") in the rear from forum vendor ($60)

[oldblue1968chevy]

http://67-72chevytrucks.com/vboard/s...454824&page=11

Where i bought mine

[NC_John]

Originally Posted by oldblue1968chevy

Cut 1 coil in the front springs
Install a drop block (2") in the rear from forum vendor ($60)

Sounds inexpensive enough... what will that give me, a 2"/2" for now?

[oldblue1968chevy]

Yes, 2" block in the rear and roughly 2" in the front. Wished I had a better pic I shot that after the truck was sitting for 8 months while I was..gone...

I have nicer pix on flat concrete but its 'stock' height in those.

[67ctener]

Posted via Mobile Device
2" spring and 2" spindle and in my opinion sits way too high. I think I got something weird just hope it's not the spindle
Posted via Mobile Device