|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-13-2021, 05:18 PM
|
#11 |
|
low n' slo
 
Join Date: Mar 2009
Location: rosenberg, texas
Posts: 5,133
|
Re: Project 67 DRGNWGN - 67 Burban!!
well, was getting ready to mate to the trans and figured I would reseal the output shaft and the slip yoke tube inside since there was trans oil on the u joint when I pulled it from the donor. the tube I can't get local so had to order it off Amazon and won't be in until the week sometime. I did get the shaft seal in...pain in the ass.
if you guys have a rear main seal alignment donut, it fits perfectly over the rubber so you can evenly tap the seal in.
__________________
67 1/2 ton Suburban - Project DRGNWGN. Build thread  -_--_--_ _________ _--_-_ -/____|__|__\__ ,.,,,.,.,,.,|_O _______ O_] |
|
|
| Bookmarks |
|
|
Threaded Mode