4l60e slip yoke

[uxdesigner]

Finally started working on the connecting the driveline and realized the slip yoke I have (TH400) is different from the 4l60e. I have the stock driveshaft, anyone know what the u joint sizes are or would it be best to hit the part store and verify prior to ordering a new yoke?

[ls1nova71]

Just get one for a 350 turbo or 700r4, they're easy to find.

[uxdesigner]

Originally Posted by ls1nova71

Just get one for a 350 turbo or 700r4, they're easy to find.

Thanks, found a few online. Would it be 1310 or 1350? Does that even matter?

[wgeyer88]

Originally Posted by uxdesigner

Thanks, found a few online. Would it be 1310 or 1350? Does that even matter?

Yes it does matter. If your truck is a 1/2 ton it should be a 1310. I would measure the u-joints on your drive shaft to make sure.

[Hart_Rod]

I have a nearly new 1330 rearend yoke, let me know if you are interested.

[uxdesigner]

Originally Posted by wgeyer88

Yes it does matter. If your truck is a 1/2 ton it should be a 1310. I would measure the u-joints on your drive shaft to make sure.

Originally Posted by Hart_Rod

I have a nearly new 1330 rearend yoke, let me know if you are interested.

Great information, really appreciate your help. I measured and its a 1310, thanks for the offer Hart_Rod.

[desertdogg]

I will be working on the drive line soon. I called a local drive shaft company and they said the slip yoke should only go in about 3/4 of an inch?.... Is this what everyone is finding??

[truckdude239]

ummm mine goes in almost 2 inchs 3/4 inch is nothing

[clinebarger]

Originally Posted by desertdogg

I will be working on the drive line soon. I called a local drive shaft company and they said the slip yoke should only go in about 3/4 of an inch?.... Is this what everyone is finding??

Is the driveline shop telling you to install the yoke & then measure for the driveshaft?

That is not the way to measure, You measure from the end of the extension housing to the center of the rear U-joint, And the Shop figures out everything else.

http://www.dennysdriveshaft.com/app/...iagrams/b.html

[desertdogg]

Originally Posted by clinebarger

Is the driveline shop telling you to install the yoke & then measure for the driveshaft?

That is not the way to measure, You measure from the end of the extension housing to the center of the rear U-joint, And the Shop figures out everything else.

http://www.dennysdriveshaft.com/app/...iagrams/b.html

Something like that..I'm confused, by extension housing, do you mean the end of the transmission like where the yoke slips in ?

[truckdude239]

Yes my drives haft shop wanted from the fatherest point on the Tran which was the out put shaft

[desertdogg]

Originally Posted by truckdude239

Yes my drives haft shop wanted from the fatherest point on tjoint ran which was the out put shaft

OK, I so I. Measure from the end of the transmission to the differenttial where the u joint fits in??