|
07-05-2012, 12:46 AM
|
#1 |
|
Registered User
Join Date: Sep 2010
Location: bucks county
Posts: 18
|
Need some help
hey guys i know this may seem like a very small question to start a thread for but i cant figure it out.... So im about to buy my rear set up to bag my 68lwb and my truck is at a friends house. so i dont have access to look at it right now. Because im impatient i need to know what the diameter of my rear axle tubes are, 68 lwb 6 lug original rear/alxes. Thanks guys
__________________
1968 Chevy c10. CPP drop and disc brake conversion. straight six 250/powerglide. YUP!!! truck club |
|
|
|
07-06-2012, 11:22 PM
|
#2 |
|
Registered User
Join Date: Apr 2011
Location: Mustang, Oklahoma
Posts: 2,807
|
Re: Need some help
Axle diameter on my two rears (12 bolt 1970,and 72) is 3.0". Should be the same diameter for all 67-72 12 bolt rears.
__________________
Dan <---(my name) 67 SWB C10 project "GEORGIA"-59 Brookwood 2dr wag...Next project-03 Tahoe 4x4 5.3 family ride-07 Hondur Accord, commuter car |
|
|
|
|
07-07-2012, 01:49 AM
|
#3 |
|
Registered User
Join Date: Jun 2012
Location: southeast texas
Posts: 210
|
Re: Need some help
you need to slow down a bit. you may get lucky and you may pay shipping to return the axles . pull your axles and measure them. make sure you do in fact have a 30 spline rear end and that its the diff that came from factory. the truck is almost 45 years old and its not uncommon for a PO to have changed it with a reman or even a new after-market rear that may be wider than the 68.
there's never seems to be enough time to do it right the first time, but there's alway time to do it over. |
|
|
|
|
07-07-2012, 01:06 PM
|
#4 |
|
Registered User
Join Date: Jul 2011
Location: Farmville, Va
Posts: 3,027
|
Re: Need some help
get it right the first time is also the cheapest way
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
