|
02-16-2013, 01:06 AM
|
#1 |
|
Registered User
 
Join Date: Nov 2007
Location: Turlock California 95380
Posts: 2,075
|
Rear Main ?
I am working on a 2000 Tahoe 4WD with a 5.3L. 135K Miles. It looks like I will be replacing the rear main seal and the oil pan gasket. Does the rear main seal require any special tools to install ? Or just pry out and tap in new seal ? Thanks in advance
__________________
72 C20 Longbed 05 1500 Z71 |
|
|
|
02-16-2013, 12:04 PM
|
#2 |
|
Registered User
Join Date: Dec 2012
Location: saskachewan
Posts: 150
|
Re: Rear Main ?
you should use tool # j 41470 to install the seal properly.
|
|
|
|
|
02-16-2013, 10:26 PM
|
#3 |
|
Registered User
Join Date: Nov 2007
Location: Turlock California 95380
Posts: 2,075
|
Re: Rear Main ?
Thanks ! That must be a GM Special service tool ? Unfortunately I didnt get that far today. I got tied up with other work... I had a heck of a time getting the studs on the tranny though
 4wd Tahoes are fun to work on 
__________________
72 C20 Longbed 05 1500 Z71 |
|
|
|
|
02-17-2013, 12:25 AM
|
#4 |
|
Registered User
Join Date: Nov 2007
Location: Turlock California 95380
Posts: 2,075
|
Re: Rear Main ?
I dont know why Im thinking about this right now since Im off of work... but would it be easier to remove the torsion bars & crossmember or remove the transfer case off the tranny to do the rear main seal ? I think Ive drunk too much tonight
I always forget about work once I leave 
__________________
72 C20 Longbed 05 1500 Z71 |
|
|
|
|
02-17-2013, 10:40 AM
|
#5 |
|
Registered User
Join Date: Dec 2012
Location: saskachewan
Posts: 150
|
Re: Rear Main ?
take the transfer case off of the trans.leave the bars in place.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
