The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Paint & Bodywork

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 11-05-2021, 08:50 PM   #1
ItWillBeSlow
Senior Member
 
ItWillBeSlow's Avatar
 
Join Date: May 2013
Location: You're the only 10 I see
Posts: 354
Painting over restored paint job

I recently acquired a nicely restored truck bed for my project that I will be repainting to change the color. I will also be welding closed some trim holes in the bed sides (40ish).

The bed is very nicely restored and almost a shame to repaint. I'm in a bit of a rush with the weather and would prefer not to strip down the current paint job, but paint over it instead.

The current paint I beleive to be DuPont Chromabase with clear.

Can I shoot SPI epoxy over the clear? What grit do I scuff with?

Since I will be welding the trim holes shut I will have some bare metal before epoxy and I would put filler over the epoxy where the holes were. Then top coat with SPI high build, seal with SPI epoxy reduced at 25%, basecoat, clear.

Is this a good plan? I realize I do not know what's under the current paint job but that is not the purpose of this thread.
__________________
1972 C20
ItWillBeSlow is offline   Reply With Quote
Old 11-06-2021, 11:04 PM   #2
PDW HOTRODS
Registered User
 
PDW HOTRODS's Avatar
 
Join Date: Nov 2006
Location: Sutherlin Oregon
Posts: 449
Re: Painting over restored paint job

It's always a gamble painting over existing paint, but if it is base/clear I would look at the quality and decide. If it looks like they did a real good job you should be fine. If you see any bodywork spots, sand scratches, or anything that looks like poor quality or cut corners then I wouldn't trust it.
PDW HOTRODS is offline   Reply With Quote
Old 11-07-2021, 05:03 AM   #3
bsarts
Registered User
 
bsarts's Avatar
 
Join Date: Jul 2019
Location: Idaho Falls, Id.
Posts: 154
Re: Painting over restored paint job

I wouldn't waste money shooting SPI epoxy over the clear, its' real value is in applying it over bare metal, which you should do where you weld up your holes. Just treat the existing paint as a base primer, sand it appropriately, give it some high-build as you planned, block it, seal it, and continue on. Just make sure there are no compatibility issues between what is already there and what you are putting on in.
bsarts is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:33 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com