Another 52 interior door panel

[oldman3]

Here I've taped scrap 1/8" plastic pieces to first layer of plastic. (This was done to help in the next step. Later 2" wide pieces of plastic will be glue to lst layer to create the pleated look)

[oldman3]

Magnets had been glued to insert panel and put into place. I put fiberglass filler around the outside edge to create a raise area.

[oldman3]

This is the back of the main panel, you can see the shape in the metal that matches the door. Vinyl has been applied to panel and glued to panel and on the back side. For this part I used vinyl top glue as on the old panel.

[oldman3]

The main panel is mounted to the door with four screws that are in the insert panel area (will be covered later and won't know their there).

[oldman3]

Another view showing magnets that will hold the insert in place.

[oldman3]

Back of insert panel with magnets showing. Notice these are flush to the metal and are glued to the plastic. While the main panel magnets were raised.

[oldman3]

Here the insert panel is in place. This is a snug fit and the magnets hold the two pieces together.