Weights of truck parts (some 1964 specific)
 

Well I'm finishing up my build and decided to weigh stuff for others to reference. Maybe it'll help someone with it being in the interwebs now. Feel free to add weights of post your variations so we can calculate a delta. Used a digital bathroom scale. Here's the list. Weights are in pounds. "PC" = powder coated

Porter Built L trailing arm "PC" - 18.7
Porter Built R trailing arm "PC" - 19.3
Porter Built trailing arm lower tie / lateral connector "PC" - 5.8
Porter Built Trailing arm cross member with adj. brackets "PC" - 22.4
Porter Built coil over upper mount cross member "PC" - 5.8
Porter Built front sway bar "PC" - 22.6
Porter Built panhard bar with frame mount "PC" - 7.5
Porter Built Front upper control arms "PC" (bare, no bolts, bushings, etc.) - 4 ea.
Porter Built Front lower control arms "PC" (bare, no bolts, bushings, etc.) - 15.6 ea

Stock trailing arm with bushings and bolt - 24.2 ea
Stock trailing arm cross member - 24.4

Moroso front springs - 15.8 ea
292 I6 stock front springs - 11.3 ea.
Rear Spring 4" drop - 8.7 ea.
Front Spindles "PC" (bare) - 23.8 ea.
Front 5x5 rotor w/ lug nuts, bearings, dust cap - 27.9 ea.
Front Caliper from 5x5 set up with pads and mounting bolts - 12.6 ea.
Inner and Outer tie rods with connection sleeve - 3.8
3/4 ton 1985 C-10 sway bar with bushings - 22

Inner fenders "PC" - 16.6 ea.
Front right fender, primed, painted, 2 coats clear with rubber under coating on inside - 12.1

Front left fender, primed, painted, 2 coats clear with rubber under coating on inside - 12.4

Rear right stepside fender. primed, painted, 2 coats clear, rubber undercoating inside of fender - 27.5

Rear left stepside fender. primed, painted, 2 coats clear, rubber undercoating inside of fender - 23.7

Drivers "step" with "L" bracket attached, fully painted w/ undercoating - 8.2
Pass. "step" with "L" bracket attached, fully painted w/ undercoating - 8.2

Cowl cover / windshield wiper linkage cover - 3.9

Master Cylinder and Booster (no fluid) - 12.6
CCP transmission brace - 6.1

Stock from 64 front glass - 23.1
Stock from 64 small rear glass - 7.1

:chevy:

Re: Weights of truck parts (some 1964 specific)
 

Cool glad somebody else had some info. My weights are real close to yours on stuff. My truck is a 68 though.

Re: Weights of truck parts (some 1964 specific)
 

Had my stock front bumper(22.4#) and hood(68.43#) off my 71 last week as i am replacing both with fiberglass units i sourced from Shakedown racing in LIndale, TX. New glass bumper weighed in @ 4.6#'s....have not received the glass 6" pin on hood yet though. Should be here any day now, bumper looked pretty good too!

Re: Weights of truck parts (some 1964 specific)
 

Yeah. The bumper is nice. I have one also. Pin on hood is about 13 lbs. Mine is a stock style hood..for now.