The sheet metal is back on and I have to say I am a little disappointed.
Below is a picture of my truck sitting on a 4" drop Sid's axle with a couple leaves removed. Notice the placement of the tire in the fender opening.
This is a picture of my truck with the Danforth Crossmember installed. Notice how the wheel is further forward in the fender opening?
I have contacted Scott and inquired about any complaints regarding the wheel not being centered in the opening. He states he has never had a complaint. I discussed with a couple friends on Facebook who are installing the same crossmember and they both have the same problem.
My first instinct was to slid the cab and front clip forward 3/4", but I do not think my distributer will allow it.
Aired out.
Ride height.
