The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Toro · 12-08-2018, 10:44 PM

Did you cut straight across, left to right? I'm looking to do the same with mine, I don't want to take the bed sides off. I'm thinking an additional cut, back to front would make it easier to get the floor out/in under the bed sides. I'll basically be patching around the good steel I have.

12-08-2018, 10:44 PM	#9
Toro Registered User Join Date: Nov 2018 Location: Huntsville, AL Posts: 340	Re: SWB truck bed steel in a Blazer Did you cut straight across, left to right? I'm looking to do the same with mine, I don't want to take the bed sides off. I'm thinking an additional cut, back to front would make it easier to get the floor out/in under the bed sides. I'll basically be patching around the good steel I have.