|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-25-2002, 12:04 PM
|
#1 |
|
Before and After
Join Date: Feb 2000
Location: Leduc, Alberta CANADA
Posts: 632
|
1/2 ton vs 3/4 ton springs
Can anyone tell me if there is a difference between the 1/2 ton and 3/4 ton springs. both front and rear. I would like to lower stance and not many options if I stay with 3/4 ton springs. I will NOT be hauling anything in or towing behind it.
I would like to change my 3/4 ton springs with 1/2 ton lowered springs, is this possible? 
__________________
Not Grandpa's C-20 anymore... 383 Stroker 425HP, 485Ft/Lbs Lowered 3.5" Front / 5" Rear 66,000 miles. Alberta, CANADA |
|
|
|
10-25-2002, 12:36 PM
|
#2 |
|
Senior Member
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,454
|
Try www.earlyclassic.com They will know.
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
