|
11-10-2006, 06:53 PM
|
#1 |
|
Registered User
Join Date: Mar 2006
Location: USA
Posts: 21,020
|
Drive shaft question
My 71 swb k10 which had a 6 inch lift had a longer custom rear driveshaft.I am putting a new 4 inch all spring lift on it and I was wondering if I should use that driveshaft or a stock one.Do the swb have a 2 piece shaft w/ a carrier bearing like the longbeds or is a stock swb k10 rear driveshaft a one piece unit?
Last edited by 1969k10stepside; 11-10-2006 at 06:54 PM. |
|
|
|
11-11-2006, 05:12 PM
|
#2 |
|
Registered User
Join Date: Mar 2006
Location: USA
Posts: 21,020
|
Re: Drive shaft question
Ttt
|
|
|
|
|
11-11-2006, 07:04 PM
|
#3 |
|
Senior Member
Join Date: Dec 2004
Location: Southern Pines NC
Posts: 3,853
|
Re: Drive shaft question
I have one complete and 2 rolling SWB trucks and they all have 1 piece rear drive shafts.
With the custom drive shaft you might bind because it is longer. Usually for stock to 4 inch lift the stock drive shaft is the deal |
|
|
|
|
11-11-2006, 07:48 PM
|
#4 |
|
Registered User
Join Date: Mar 2006
Location: USA
Posts: 21,020
|
Re: Drive shaft question
This driveshaft extends in and out so I was wondering if it will work.I guess I need to take some measurements.
|
|
|
|
|
11-11-2006, 09:27 PM
|
#5 |
|
Senior Member
Join Date: Dec 2004
Location: Southern Pines NC
Posts: 3,853
|
Re: Drive shaft question
cycle the suspension to see if it binds
|
|
|
|
|
11-11-2006, 10:32 PM
|
#6 |
|
Registered User
Join Date: Mar 2006
Location: USA
Posts: 21,020
|
Re: Drive shaft question
Nothing is hooked up now,the t-case or axle isnt even together.I just want to know if I should rebuild this or look for a stock one to use.Here is a pic of this custom one extended and un-extended.Anyone ever seen one like this?
I think I should start looking for a stock drive shaft. Attachment 224326 Attachment 224327 Last edited by 1969k10stepside; 12-11-2006 at 10:22 PM. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
