|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-10-2002, 11:06 PM
|
#1 |
|
Seņor Member
Join Date: May 2002
Location: Edge of the world
Posts: 5,367
|
Fleetside floor dimensions?
I'm contemplating transplanting a steel floor into my stepside bed. Has anyone got a tape measure handy to see how wide the main piece of floor is that goes between the wheel wells?
Thanks, Kenneth
__________________
|
|
|
|
11-11-2002, 12:08 AM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
Fleetside , tub to tub? I have 39 1 1/2", & the tubs are stretched 5".......so stock should be 49 1/2. Im guessing, you plan to cut down a fleet floor to use on the step?
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
11-11-2002, 01:46 PM
|
#3 | |
|
Seņor Member
Join Date: May 2002
Location: Edge of the world
Posts: 5,367
|
Quote:
Kenneth
__________________
|
|
|
|
|
|
11-11-2002, 01:53 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
I think it might work, & should look good. Your front box panel will be 3/4" too tall, but the mount lip can be cut off & refolded. good luck, & let us know how it goes.....
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
