The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 01-25-2015, 05:25 PM   #1
Krex
Registered User
 
Join Date: Nov 2014
Location: Dallas
Posts: 529
Help smoke from steering column

Help smoke from steering column, after I pushed in the Hazard switch, now the ignition switch will not turn on acesseries or start engine.

Can some please help me diagnose the problem?
Krex is offline   Reply With Quote
Old 01-25-2015, 06:10 PM   #2
SS Tim
Registered User
 
SS Tim's Avatar
 
Join Date: Aug 2010
Location: Edwards, CA
Posts: 7,503
Re: Help smoke from steering column

Since the Hazards are on their own fuse it sounds like you may have fried the fusable link at the battery. Did you find the cause of the smoke? Is the battery still charged?
SS Tim is offline   Reply With Quote
Old 01-25-2015, 06:52 PM   #3
Krex
Registered User
 
Join Date: Nov 2014
Location: Dallas
Posts: 529
Re: Help smoke from steering column

I think I may have found the problem. any suggestions as to go about fixing it?
Attached Images
 
Krex is offline   Reply With Quote
Old 01-25-2015, 06:53 PM   #4
Krex
Registered User
 
Join Date: Nov 2014
Location: Dallas
Posts: 529
Re: Help smoke from steering column

Another pic
Attached Images
 
Krex is offline   Reply With Quote
Old 01-25-2015, 06:54 PM   #5
Krex
Registered User
 
Join Date: Nov 2014
Location: Dallas
Posts: 529
Re: Help smoke from steering column

Another picture
Attached Images
 
Krex is offline   Reply With Quote
Old 01-25-2015, 07:33 PM   #6
SS Tim
Registered User
 
SS Tim's Avatar
 
Join Date: Aug 2010
Location: Edwards, CA
Posts: 7,503
Re: Help smoke from steering column

That is not the cause, but the result unless it was contacting grounded metal.
Might start with the factory service manual pages 12-33 and 12-34.
Easy enough to fix though with another terminal and a pigtail to splice in. But that purple wire only feeds the switch from the fuse block tap.

Like I said earlier you might have fried the fusable link. Check it and all your fuses/wiring for damage.

* VIN/Model Decoders
* Power Team Charts (engine/transmission/gear ratio)
* Post Your Pickup SPID Blazer SPID Suburban/Panel SPID
* RTFM
... Read The Factory Manuals... download 'em here
SS Tim is offline   Reply With Quote
Old 01-25-2015, 10:35 PM   #7
Krex
Registered User
 
Join Date: Nov 2014
Location: Dallas
Posts: 529
Re: Help smoke from steering column

Where is the fusible link you say I could have fried I checked all fuses for continuity theses where the fuses that blew.

Traffic Haz 15 amp
Tail stop park dome 20 amp
Glove box spot lamps 15 amp

I do have the service manaul and I am reviewing 12-33 and 12-34
Not too good with wiring diagrams I get how to flow the spaghetti to next item, but that is really it.
Krex is offline   Reply With Quote
Old 01-25-2015, 10:37 PM   #8
Krex
Registered User
 
Join Date: Nov 2014
Location: Dallas
Posts: 529
Re: Help smoke from steering column

Just to note wipers won't work either just my headlight switch seems to work.

Also repaired the purple line for now by just jumping the turn signal harness pigtail.
Krex is offline   Reply With Quote
Old 01-25-2015, 11:23 PM   #9
Ozzy2013
Registered User
 
Ozzy2013's Avatar
 
Join Date: Oct 2013
Location: Elkton
Posts: 693
Re: Help smoke from steering column

The fusible link is some times up by the firewall on the driver side and i think there is one in the wire going to the starter .Looks like you may have had a dead short in the column .I would start by testing the wring for opens and dead shorts with a fluke meter.The harness isnt to bad to replace in the column just have to pull the whole thing out .
Ozzy2013 is offline   Reply With Quote
Old 01-27-2015, 12:19 AM   #10
Krex
Registered User
 
Join Date: Nov 2014
Location: Dallas
Posts: 529
Re: Help smoke from steering column

Quote:
Originally Posted by Ozzy2013 View Post
The fusible link is some times up by the firewall on the driver side and i think there is one in the wire going to the starter .Looks like you may have had a dead short in the column .I would start by testing the wring for opens and dead shorts with a fluke meter.The harness isnt to bad to replace in the column just have to pull the whole thing out .
I have not seemed to find it yet do you have a picture of what it looks like? is it under the hood or near the fuse box inside the cab?
Krex is offline   Reply With Quote
Old 01-27-2015, 01:36 AM   #11
Ozzy2013
Registered User
 
Ozzy2013's Avatar
 
Join Date: Oct 2013
Location: Elkton
Posts: 693
Re: Help smoke from steering column

Under the hood
Ozzy2013 is offline   Reply With Quote
Old 01-27-2015, 08:19 PM   #12
franken
Registered User
 
Join Date: Jun 2013
Location: Somewhere
Posts: 3,057
Re: Help smoke from steering column

The link should be between the battery + and the junction block on the passenger fender. They are often gone.
Do you have working headlights or horn? If yes, its not a fusible link issue.
franken is offline   Reply With Quote
Old 01-28-2015, 01:37 AM   #13
VetteVet
Msgt USAF Ret

 
VetteVet's Avatar
 
Join Date: Jan 2005
Location: Kalamazoo, Michigan
Posts: 8,707
Re: Help smoke from steering column

These two diagrams will show how the hazards and other stuff you have that is not working and they should explain why they quit working. Mr. Franken is correct, if your lights and horn are working then the fusible link is good.

This diagram shows the accessory wire from the key switch which powers the hazard lights fuse and the wipers and heater fan switch. It is the 3rd one down from the top and is a 12 gauge wire. It is shown by the arrow.

Name:  Cab-2-web.jpg
Views: 324
Size:  104.5 KB



This is the back side of the fuse panel and the arrows show the accessory wire coming in to power the fuses for the things that no longer work. It also connects to the key switch battery wire and I suspect that the short from the column connector has blown the key switch connection to the brown accessory wire. especially if all the fuses are good.

Name:  Cab-1web.jpg
Views: 237
Size:  101.1 KB
__________________
VetteVet

metallic green 67 stepside
74 corvette convertible
1965 Harley sportster
1995 Harley wide glide

Growing old is hell, but it beats the alternative.

Last edited by VetteVet; 01-28-2015 at 01:44 AM. Reason: diagrams
VetteVet is offline   Reply With Quote
Old 01-28-2015, 05:22 PM   #14
Fitz
Account Suspended
 
Join Date: Jan 2007
Location: Tucson
Posts: 2,183
Re: Help smoke from steering column

Quote:
Originally Posted by Krex View Post
Help smoke from steering column, after I pushed in the Hazard switch, now the ignition switch will not turn on acesseries or start engine.

Can some please help me diagnose the problem?
The smoke needs to be kept inside for things to work properly. Once you let it out you need to replace the wiring with new wires and connectors that still hold the smoke in for stuff to work.
Fitz is offline   Reply With Quote
Old 01-28-2015, 08:04 PM   #15
Tinkermc
Registered User
 
Join Date: Jul 2011
Location: Farmville, Va
Posts: 3,026
Re: Help smoke from steering column

If you let the smoke out of the column, generally bad news. Just my 2 cents.
Tinkermc is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:24 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com