Computer mount pictures

[elf w/capital T]

I'm thinking about mounting mine on the passenger side firewall (engine bay side) where the heater box use to be. Dash is a no, floor is not even a question since I have the molded carpet, but have thought about cutting the new high hump to make flush mounted but meehhh...

[Hart_Rod]

Passenger's side core support

[elf w/capital T]

Hartrod, thats clean! I take it you relocated the battery tray? I'm now debating firewall and or the core support, homemade mount/bracket?

[Hart_Rod]

Originally Posted by elf w/capital T

Hartrod, thats clean! I take it you relocated the battery tray? I'm now debating firewall and or the core support, homemade mount/bracket?

I had to put the battery under the bed due to the raised front rear tubs not allowing for use in the factory location. I purchased the bracket from someone on the internet, but I can't remember who.

EDIT: Here's where I got it: http://www.ironworksspeedandkustom.c...prod/prd61.htm

[Nodnarb76]

Mounted mine to the drivers side fender using the Dirty Dingo mount.

[izzy_Britton]

Originally Posted by foamypirate

This comment adds nothing to the conversation. He is probably in the middle of the install...

I was not trying to be condescending. I was just thinking out loud. the wiring is the one and only thing i dread about my swap. I still havent made up my mind 100% where i am going to mount mine. planning behind glove box but as i said, dread the spaghetti i am gonna need to deal with.

[Rich84]

I plan on putting mine under the dash in the same location as the original 1984 computer, and where my current TPI Ecm is.

My question: Has anyone put it under the dash with a vintage air system? I plan on adding one down the road. Is there room?

[Chris Coufal]

[foamypirate]

[IMG]Not the best picture, but I am using the Tejas Steelworks ECM mount with a small mod to my ECM mounting (longer standoffs) due to my harness routing.

[/IMG]