Here's a simple solution to center speakers

[par4tom]

More mocking up. Once I got the bottom tier done, I wrapped it in carpet that matched the carpet of the truck. I did it this way to minimize the look of the center console as a whole. I felt if the piece was all vinyl...it would look bulky and boxy...

[par4tom]

Covered bottom piece in carpet...started on the top section with the Ipad.

NOTE - The big Ipad was to big to fit so I ditched the idea in favor of a mini Ipad4...glad I did...as it wouldn't have been proportional

[par4tom]

Working on getting the top lines to flow and still fit under the jumpseat...lot of trial and error...

[par4tom]

Got stuck on ideas for the IPad piece, so I moved to the shifter surround piece for a while...

With the outlines of the shifter piece done, I nailed it together then wrapped it in fleece for resin...

[par4tom]

Resin....

Test for fit...

Mock up with IPad Mini and check for fit again...(My son couldn't leave the IPad alone...playing Minecraft)

[par4tom]

My son likes the truck simply for the Ipad...lol!!!

[par4tom]

Everything was looking good but then I realized than I was not going to be able to retain the jump seat. Too much of the electronics are in this console due to space limitations. And to keep the jumpseat, I would have had to remove all three seats just to change a fuse...

Bummer...I took a week off after this...