'64 chevy 2wd to 4wd

[Ol Blue K20]

It's looking great so far. I like the vent window in the rear doors.

[dieseldawg142]

thanks Dale!
even though i personally think they look ugly, went with stock pillars this time
have been thinking along these lines for a motor. only thing that bugs me, it's not a very "symmetrical" looking set-up, looks a little lop-sided to me...
maybe a little overkill for a 4by..? either way, the plan is to bling the six up a bit



did have a big set back on the int. i'm guessing i must have accidently knocked my bag of int parts off the bench into my garbage can, cause i have ripped my room apart 2wice, and found nothing, and these are'nt small parts...
i tried to scab the '66's floor pan, seat and door panels onto the '60's, but as you can see, it looks like s**t, nothing matches at all, not even the seat pattern...


this is a bummer, took the wind out of my sails on it....temporarily

[dieseldawg142]

...'till today...
remember the '66 sub my wife pre-ordered the other month, well ye haw, look what showed up in the mail today


here's what the rest of it looks like. a lot of the '66 truck tooling here. chrome rack is lifted right from the pickups. like the 2 piece barn doors. decals are'nt bad either, dont have to print up gauge decals for it


going to build this one now, '60 crew is on hold 'till i can figure out another int.
plan is to get rid of the glass and turn it into a 4x4 panel sub

[dieseldawg142]

...something along the lines of this...