Looking for pic of 60-66 k10 bellhousing crossmember - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Brad54 · 12-29-2018, 10:41 PM

Dang, that's a big PTO hole. I didn't think about it, but I guess I'll need to do one on my '62 K10: I've got an NP205 and a PTO winch set-up for it. Given that everything is pretty much rigidly mounted, the hole probably doesn't need to be that big.
Is you're gusseted or reinforced?

dieseldude4bt · 12-31-2018, 04:56 PM

Quote:

Originally Posted by Brad54

Dang, that's a big PTO hole. I didn't think about it, but I guess I'll need to do one on my '62 K10: I've got an NP205 and a PTO winch set-up for it. Given that everything is pretty much rigidly mounted, the hole probably doesn't need to be that big.
Is you're gusseted or reinforced?

You wont need to go through the crossmember if you put a flange bearing there and u-joint and run the shaft under it like I did mine.

12-29-2018, 10:41 PM	#1
Brad54 Registered User Join Date: Aug 2006 Location: Athens, Georgia Posts: 1,456	Re: Looking for pic of 60-66 k10 bellhousing crossmember Dang, that's a big PTO hole. I didn't think about it, but I guess I'll need to do one on my '62 K10: I've got an NP205 and a PTO winch set-up for it. Given that everything is pretty much rigidly mounted, the hole probably doesn't need to be that big. Is you're gusseted or reinforced? __________________ '61 Suburban daily driver: off the road due to 180-pound 8-pt buck! '62 K-10 long-step project '61 C30 Camper, aka "Valdez" There's no cool like Old School



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.