How to: Ruin a perfectly good C10 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

04-09-2020, 01:32 PM

#11

SCOTI

Registered User

Join Date: Apr 2001

Location: DALLAS,TX

Posts: 21,919

Re: How to: Ruin a perfectly good C10

Quote:

Originally Posted by cornerstone

How much clearance are you allowing around the tightest places for your driveshaft? I'm in the middle of this now also and not sure if I should trim my cab floor also. It looks like I've got about 3/4 of an inch after I install my driveshaft.

Bottom the suspension out completely & make sure the d.shaft doesn't contact anything. If it does, trim things back until it doesn't. I usually build things w/a 1/8" thick (yard stick) spacer to pad my clearances.

__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG

Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....

Cubic inches is like Indiana Jones with a cheap pistol.

Bookmarks

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 03:22 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.