Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
11-14-2019, 09:09 PM | #1 |
Senior Member
Join Date: Jan 2015
Location: Tampa, Fl.
Posts: 421
|
Headers and the trans mount
1980 C10 1/2 ton. I put a new engine and trans (350/350) in the truck, when I bought it, it came with headers new in the box so I figured I'd use them too. Headmans. They fit great except my drivers side header points straight at the trans mount.
I could do some crazy angles on the exhaust pipe but it seems to me it's easier to just cut the trans mount in half and weld another piece to it and make it go straight across rather than dip down like the stock one does. I have an extra trans mount so I could use the pass side of that mount. Any reason this won't work? Any other ideas aside from dipping the pipe? I have a nice set of pipes with an H pipe already and would like to just bolt it on. Thanks for your tips.
__________________
1965 C-10 1/2 ton shortbed part time daily driver 1980 C-10 1/2 ton shortbed project |
Bookmarks |
|
|