71 C25 - Motor/Tranny suggestions requested - The 1947 - Present Chevrolet & GMC Truck Message Board Network

00burb253 · 05-20-2016, 02:13 PM

Hi folks,

i'm new to the forum and looking for some advice. I have a tired 350 with a turbo 350 in my 3/4 ton. I would consider myself intermediate on the mechanical side. I have a 3 ton hoist to pull out something and put something in. So what is an economical power solution?

Thank you!

stomper · 05-20-2016, 02:41 PM

If the 350 is in fact worn out I'd say your most economical solution is a long block from a reputable local rebuilder. You should be able to get that for under $1000.

What makes you think it's 'tired'? I've bought vehicles that the PO was going to do a rebuild or replacement on but the motor just needed some attention. Tune-up, etc...

P.S. Welcome to the board!

00burb253 · 05-20-2016, 02:52 PM

Maybe I should edit the comment, she drives likes she's tired. I don't expect too much from her as she is miss dependable. Lots of leaks, rear main, valve covers are leaking...she deserves some pep as well.

I just watched this and now I'm drooling but I think that contradicts my economical comment.

http://www.powerblocktv.com/episode/...p#.Vz9cuo-cElw

05-20-2016, 02:13 PM	#1
00burb253 Registered User Join Date: May 2014 Location: Puyallup Posts: 4	71 C25 - Motor/Tranny suggestions requested Hi folks, i'm new to the forum and looking for some advice. I have a tired 350 with a turbo 350 in my 3/4 ton. I would consider myself intermediate on the mechanical side. I have a 3 ton hoist to pull out something and put something in. So what is an economical power solution? Thank you! Attached Images

05-20-2016, 02:41 PM	#2
stomper Junior Member Join Date: Jul 2002 Location: Scottsdale, AZ Posts: 1,695	Re: 71 C25 - Motor/Tranny suggestions requested If the 350 is in fact worn out I'd say your most economical solution is a long block from a reputable local rebuilder. You should be able to get that for under $1000. What makes you think it's 'tired'? I've bought vehicles that the PO was going to do a rebuild or replacement on but the motor just needed some attention. Tune-up, etc... P.S. Welcome to the board! __________________ "I was patina when patina wasn't cool." 1973 Cheyenne SWB Gold White Fleetsides/Saddle

05-20-2016, 02:52 PM	#3
00burb253 Registered User Join Date: May 2014 Location: Puyallup Posts: 4	Re: 71 C25 - Motor/Tranny suggestions requested Maybe I should edit the comment, she drives likes she's tired. I don't expect too much from her as she is miss dependable. Lots of leaks, rear main, valve covers are leaking...she deserves some pep as well. I just watched this and now I'm drooling but I think that contradicts my economical comment. http://www.powerblocktv.com/episode/...p#.Vz9cuo-cElw



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.