let's see some engine compartments.

[boatpuller]

i know this has been done before.but,there's a lot of new guy's on here.i'm upgrading under the hood. and would like to see what others have done.

[jr2]

Not completely finished yet but here ya go...

[cliffsta]

I went from this:


To this:


Squat compared to what others have done, but a lot to me.

[Russell]

Here is mine!



I've cleaned the wiring up a bit, swapped a new serp kit on that relocates the alt to the other side, and relocated the cruise control module, but looks basically the same

Oh, I do have a front clip on now too, lol

[pcmcobra]

great thread, I have been looking for some ideas for mine, just did not think enough to post.
Looking good.

[jdmaffeo]

Here is mine that is still under construction.

[stepside454]

here is mine, figured we need some big blocks in the mix

[75stepside]

Here's my $.02







more pix @ my webpage:

[68GMC454]

well i dont have pics,,but just think 454,,leaks oil from about anywhere it can leak from..covered in grease oil and road dirt...i got a gasket kit for it,,bu thave not got around to pulling the motor to put it in..waiting till it starts warming up,,maybe this next summer since i sold my bussiness...of course after i get my 68 up and runing...then its time to get busy on the 84..its my first baby,,so b4 i get to invloved with the 68 other than an engine for it,,the 84 is first to get rebuilt...
billy

[bagged70]

here is the start of mine

[bagged70]

heres the start of mine

[odie82]

my 350

[84 400]

sweet thread. i gotta clean mine up for shows i have a nice looking motor but the compartment looks sad

[Mistertrustee]

Sweet forum...lol!!! Here's a few picts of what we have planned for my wife's 73 K20. Going from a 454 to a 6.0 Vortec. Enjoy

[Russell]

Very nice! Just need a 32 spline NP241 pass drop t-case

[Mistertrustee]

Originally Posted by Russell

Very nice! Just need a 32 spline NP241 pass drop t-case

Nah.........just gave me an excuse to upgrade the D44 to a 60..lol

[boatpuller]

man,there's alot of sweet ones so far...anybody know what will take that undercoating looking crap off the firewall without wrecking the paint?

[Billla]

Originally Posted by jdmaffeo

Here is mine that is still under construction.

Is that the GM Performance Parts serpentine belt system?

[Russell]

Thats a TPI serp setup, I've got an identical setup on my truck now.

And very nice D60 too -- I wish I could afford one of those suckers

[jdmaffeo]

I was able to get the entire setup nutts, bolts, alt, ps pump, etc.. off of a donor 1992 Firebird. But yes I do believe that it is identical to the GM performance parts kit.

[hiway]

[pcmcobra]

Originally Posted by jdmaffeo

I was able to get the entire setup nutts, bolts, alt, ps pump, etc.. off of a donor 1992 Firebird. But yes I do believe that it is identical to the GM performance parts kit.

been looking for a serp setup...looks good

[rage'nrat638]

heres mine

[84slopwaggin]

Here ya go.

[TwinTurbo]