|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-21-2013, 10:51 PM
|
#1 |
|
Account Suspended
 Join Date: Oct 2012
Location: here
Posts: 2,408
|
Pick it up - Make offer, Excellent 65 I6 clutch/pressure plate/bearing/flywheel
Local pick up only.
Very nice condition. Pics later. Just removed it from my 65 C10, it was installed on a 71 Olds 250 motor. I'd estimate mileage on it is under 10K....I put 8k trouble free miles on it. I'll get all the measurments but I'm pretty sure its a 10" set up and I'll measure the flywheel too. No, the flywheel is not drilled for 11" set up. Flywheel and pressureplate are pretty smooth and the clutch looks fine/plenty of friction material. No noise from the throwout bearing. It was all removed to reengine and install a T5. Its good enough Shape I'd put it behind any 230 or 250 and drive it as is with no concerns. No I will not ship....darn heavy and too expensive to mess with shipping. Local Pick up only. Was $60 Now its MAKE OFFER PM. Last edited by Sharps40; 11-26-2013 at 06:51 AM. |
|
|
11-25-2013, 06:25 AM
|
#2 |
|
Account Suspended
Join Date: Oct 2012
Location: here
Posts: 2,408
|
Re: 1965 I6 Flywheel, Clutch/pressure plate/throwout bearing
Up to the top. Good clutch setup for someone. Pick it up here, make offer!
|
|
|
|
| Bookmarks |
|
|
Linear Mode
